Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric Current Shell Thickness

Posted 4 mag 2016, 15:01 GMT-4 Low-Frequency Electromagnetics Version 5.0 0 Replies

Kelly Odgers
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Everyone,

Im working on simulating the electric potential over a hollow cylinder with some thickness d. What Im curious about is how the built in shell thickness variable plays a part in the simulation. If I set it to be my thickness d, but select both the inner and outer boundaries of the cylinder then does it compute two separate shells? If I select only one boundary then in what direction is the shell extruded in the computations, inward or outward?

Thanks for any and all input, when I looked through the ACDC manual it mentions the shell thickness but doesn't describe its role.

Attachments:

0 Replies Last Post 4 mag 2016, 15:01 GMT-4
COMSOL Moderator

Hello Kelly Odgers

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content