Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
bioheat
Posted 18 set 2016, 05:04 GMT-4 RF & Microwave Engineering, Heat Transfer & Phase Change Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
I am going to investigate light distribution in brain layers which is exposed by wavelengths of IR and visible lights and then check their "heat transfer" by "bioheat" section in Comsol.
How can I create ramp , pulsed and sine sources so that I can change their amplitude and duty-cycle and frequency (time duration) myself as inputs in Comsol?
I used wave optics from optics module to study light distribution. Is it correct to use " wave optics" or not, should I used RF module instead? I could not find any example of wave optics and bioheat transfer altogether.
thank you very much beforehand,
Sheida
Hello Sheida Bayat
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.