Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Creeping flow sliding and moving wall

Please login with a confirmed email address before reporting spam

Hello everyone,

Im using the creeping flow module to simulate a sphere in fluid that is translating along one axis (say y) and rotating about one axis (say z), simultaneously. I have successfully done both motions individually (translation with moving wall BC, rotation with sliding wall BC). How can I combine both these motions, since adding one wall node below the other overwrites the first?

Thank you,
Adam

0 Replies Last Post 20 set 2016, 00:56 GMT-4
COMSOL Moderator

Hello Adam Woodman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.