Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Splitting geometry surfaces
Posted 28 dic 2010, 17:49 GMT-5 MEMS & Nanotechnology, Interfacing, MEMS & Piezoelectric Devices, Geometry Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
I've made a MEMS device in Pro/e and am using the LIVELINK for Pro/e module to use the pro/e geometry in COMSOL.
The issue i'm having is that i need to split my top surface into two parts so that i can apply a voltage and ground BC to the model.
I was wondering if anyone has experiance in splitting surfaces in Pro/e, or any ideas that i could try in COMSOL.
Thanks!
Hello aiyoung
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
i don't realy sure whether you already solve the problem or not.
In comsol you can make cutting face on a workplan. and after you finalize the geometry, the parts or surface should be splited.
i hope it helps.