Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
how to change shell midsurface direction?
Posted 29 ott 2016, 07:13 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I dont find answer how to change shell midsurface direction? This cause me problem when inserting force into faces. Ideal situation is that gray suppose to be outside of the tank and yellow suppose to be inside...now they are mixed
I dont find answer how to change shell midsurface direction? This cause me problem when inserting force into faces. Ideal situation is that gray suppose to be outside of the tank and yellow suppose to be inside...now they are mixed
Attachments:
1 Reply Last Post 31 ott 2016, 08:18 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hi,
The orientation of the normal is implicit from how the boundaries are defined in the geometry, and you cannot change it manually without modifying the geometry.
In your case, when the geometry is so regular, you could rather easily modify the loads instead. The most straightforward is to specify the face load as a vector, so that you provide the orientation explicitly. If, however, you need a pressure load because you model a follower load in a geometrically nonlinear analysis, you can enter the load something like
if(shell.anx>0,-p,p)
for each side of the box. Here shell.an is vector describing the orientation of the shell normal.
Regards,
Henrik
The orientation of the normal is implicit from how the boundaries are defined in the geometry, and you cannot change it manually without modifying the geometry.
In your case, when the geometry is so regular, you could rather easily modify the loads instead. The most straightforward is to specify the face load as a vector, so that you provide the orientation explicitly. If, however, you need a pressure load because you model a follower load in a geometrically nonlinear analysis, you can enter the load something like
if(shell.anx>0,-p,p)
for each side of the box. Here shell.an is vector describing the orientation of the shell normal.
Regards,
Henrik