Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

'Form assembly' of an imported 2D axisymmetric geometry

Posted 20 gen 2017, 03:15 GMT-5 Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2a 0 Replies

Jonah Kadoko
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My problem is that, when I 'form assembly' in the geometry section, my resulting 'assembly' still appears as if it is a union and I run into problems when I implement contact pairs at the interfaces of a multi-part 2D geometry. And when I mesh the resulting 'assembly', I get a continuous mesh at the interfaces as if it is a union.

The background is that, I imported a .dxf of a 4-part assembly that is axisymmetric. In the .dxf, the parts share boundaries in some areas. I was wondering if there is a way to make sure there are no shared boundaries? Or is there a sequence of tasks that is should do when I import .dxf assemblies?


0 Replies Last Post 20 gen 2017, 03:15 GMT-5
COMSOL Moderator

Hello Jonah Kadoko

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content