Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Getting rid of mesh artefacts.

Posted 27 gen 2011, 05:21 GMT-5 1 Reply

Chris McCorquodale
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Does anyone have any tips other than just improving the mesh? Or is there any way to get them to be ignored?

Thanks,

Chris
1 Reply Last Post 28 gen 2011, 11:00 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 gen 2011, 11:00 GMT-5
Hi

Meshing is hard works and some art, a good mix. But no I mostly check to defeature my CAD geometry, and ensure I have clean domain and boundary junctions with no small silverface or edge overlaps.

In 2D you can box a region and have a local mesh improvement (at least in 3.5, cannot remember if already there in 4.1

--
Good luck
Ivar
Hi Meshing is hard works and some art, a good mix. But no I mostly check to defeature my CAD geometry, and ensure I have clean domain and boundary junctions with no small silverface or edge overlaps. In 2D you can box a region and have a local mesh improvement (at least in 3.5, cannot remember if already there in 4.1 -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content