Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
model simplification
Posted 24 lug 2017, 12:33 GMT-4 Version 5.2 0 Replies
Please login with a confirmed email address before reporting spam
I am designing a piezoelectric material. My ideal design is that infinite numbers of hexagonal prisms connect with each other and there is no boundary between every two prisms, it will looks like a infinitely huge honeycomb. Ideally, I only want to make one hexagonal prism, then using boundary conditions to set infinite loops to repeat hexagonal prisms connected one by one, because there is no way to plot a infinitely big model. In brief, it looks like that I do the simulation on one hexagonal prism, but actually it is on a huge honeycomb structure, since the single cell is symmetric. So is it possible to realize it?
Could anyone give me some technical supports to figure out this problem?
Thank you very much.
Hello Yi Cai
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.