Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Beam and 3D solid connection

Posted 8 ago 2017, 02:28 GMT-4 Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics Version 4.4, Version 5.2 0 Replies

Sumanta Haldar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to model a Euler-Bernoulli beam embedded in solid. The part of the beam is projected above the solid. I would like to apply a point load (lateral) at the top of the beam (at the projected part) and analyze the problem. I would like to observe stresses in solid due to applied load on the beam. If the entire beam is fully embedded into the solid, the problem is working with general extrusion command. However, it is not working if the beam is partly projected above solid. Can anyone help how to make the coupling with projected and embedded part of the beam and link with solid?

0 Replies Last Post 8 ago 2017, 02:28 GMT-4
COMSOL Moderator

Hello Sumanta Haldar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content