Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
problem in implementing laminar inflow as BCs in 5.2
Posted 26 ago 2017, 09:47 GMT-4 Fluid & Heat Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello friends,
I have built a microfluidic model in COMSOL 5.2. It's a basically 2D long pipe. I tried to use 'laminar inflow -> flow rate' and 'laminar outflow -> pressure' as inlet and outlet BCs respectively. But the software failed to give an answer. Instead, if I specified pressure at both boundaries, then it succeeded to give a result. So how can I use the 'flow rate' as an inlet BC properly?
I have built a microfluidic model in COMSOL 5.2. It's a basically 2D long pipe. I tried to use 'laminar inflow -> flow rate' and 'laminar outflow -> pressure' as inlet and outlet BCs respectively. But the software failed to give an answer. Instead, if I specified pressure at both boundaries, then it succeeded to give a result. So how can I use the 'flow rate' as an inlet BC properly?
1 Reply Last Post 30 ago 2017, 06:49 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Hi Jin
What do you mean with "failed to give an answer"? Didn't reach convergence, output an error (if yes what error), results not physically real?
Did you defined properly the units?
What do you mean with "failed to give an answer"? Didn't reach convergence, output an error (if yes what error), results not physically real?
Did you defined properly the units?