Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to simulate contact with transient analysis?

Please login with a confirmed email address before reporting spam

Hi,

I am simulating slab with surface crack in heat transfer & solid mechanics domain.I have given contact pair at the crack faces.I have to do transient analysis.Some error is coming during simulation.It tells some initial value is missing. I s it possible to simulate contact physics with transient analysis?/
Pls help..


Regards!!


Deepak

1 Reply Last Post 14 mar 2011, 09:24 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14 mar 2011, 09:24 GMT-4
Hi

I belive so, but the best is always to check your initial values with a load initial values (in v4 right lick on the Dependent Variables node and "Compute to selected"

--
Good luck
Ivar
Hi I belive so, but the best is always to check your initial values with a load initial values (in v4 right lick on the Dependent Variables node and "Compute to selected" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.