Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2-layer voice coil simulation

Posted 3 apr 2018, 03:06 GMT-4 Electromagnetics, Low-Frequency Electromagnetics Version 5.3a 1 Reply

Vasileios Bountourakis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am doing a magnet simulation of a loudspeaker motor in COMSOL and the specification says it’s a 2 layer voice coil. Is there a way to define a 2 layer voice coil in COMSOL? Do I just need to put the total number of turns in the 2 layers or is there a way to specify the number of layers in the voice coil? Thank you

1 Reply Last Post 9 apr 2018, 06:50 GMT-4
Johannes Gräwer COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 9 apr 2018, 06:50 GMT-4

Dear Vasileios Bountourakis,

in order to obtain support from COMSOL, please ask your question directly via the Support Center.

Best Regards, Johannes Gräwer

Dear Vasileios Bountourakis, in order to obtain support from COMSOL, please ask your question directly via the [Support Center](https://www.comsol.com/support). Best Regards, Johannes Gräwer

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content