Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coil group

Posted 17 mag 2018, 12:03 GMT-4 Low-Frequency Electromagnetics Version 5.3 1 Reply

Paulo Seixo
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I'm modeling a permanent magnet machine and I need to configure a set of coils as in the attached image. I will be really grateful if anyone could help.

Regards, Paulo

1 Reply Last Post 17 mag 2018, 22:51 GMT-4
Nirmal Paudel Tribhuvan University/Electrical Engineering
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 17 mag 2018, 22:51 GMT-4

Hi Paulo, You can get the example of 2D generator model as well as 3D here in the link below:

https://www.comsol.com/model/modeling-of-an-electric-generator-in-3d-20191

Hope this helps.

Nirmal Paudel

Hi Paulo, You can get the example of 2D generator model as well as 3D here in the link below: https://www.comsol.com/model/modeling-of-an-electric-generator-in-3d-20191 Hope this helps. Nirmal Paudel

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content