Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error in elPlastic element.

Posted 22 mag 2018, 23:17 GMT-4 Geomechanics Version 5.2a 1 Reply

锰 富
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I ran a geomechanical model and I got this Error "Error in elPlastic element. - Detail: Lambda non positive for plastic point" , I decreased the time step and tighten the convergence tolerances acccording to an apply in this fourm. However, it didn't work.

Could anyone tell me why this error happens. I used plasticity model.

1 Reply Last Post 23 mag 2018, 04:04 GMT-4
Ed Gonzalez COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 23 mag 2018, 04:04 GMT-4

Hi 锰 富, Could you please upload your model? Thanks Ed

Hi 锰 富, Could you please upload your model? Thanks Ed

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content