Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric sweep modifying component definitions and materials

Posted 14 giu 2018, 12:56 GMT-4 Low-Frequency Electromagnetics, Parameters, Variables, & Functions Version 5.3a 0 Replies

Evan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am modelling a simple parallel plate capacitor in 2D with plate length "L" and air gap "d". When I set up a Parametric sweep over the variable d and run the simulation, the geometry, materials, and boundary conditions of the original component become modified.

For example, before the parametric sweep computes the gap material is "air", but afterwards when I check the materials I find that the gap material has become "aluminum" (the material of the parallel plates).

Is there a specification I am missing in setting up the parametric sweep, or is this a bug?

Thanks

Evan

0 Replies Last Post 14 giu 2018, 12:56 GMT-4
COMSOL Moderator

Hello Evan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content