Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

digital microfluidic

Posted 23 mag 2011, 07:21 GMT-4 0 Replies

Marco Arborio
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I'm using Comsol v4.1 for modeling the electrowetting phyisic,
When I run the simulation in Stationary there is no problem and also the results are good,
the problem comes when I try to use Time Dependent solver, the error is always:
"failed to find consistent initial values". I think that the boundary conditions are correct. I have also tried to store the solution from stationary solver and then use it in time dependent but no results.

Can any one suggest me something?

Thanks all

Bye Bye
0 Replies Last Post 23 mag 2011, 07:21 GMT-4
COMSOL Moderator

Hello Marco Arborio

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content