Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

earth science module

Posted 9 giu 2011, 13:40 GMT-4 Porous Media Flow Version 4.1 3 Replies

Marios Karaoulis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I want to simulate an fracture, where water can flow.
I divided my geometry to into a low Permeability (10e-20) and Storage =0,
and the fracture that presents 3 zones with permeability
zone1=10e-12
zone2=10e-10
zone3=10e-8

I have defined as boundary conditions no flow everywhere but the fracture zone.
In the fracture zone (up and down) I have defined a Hydraulic Head.

My concern has to do with the the velocity field, where to the edges of the fracture, I observe high and low velocities.

Why is that?



Attachments:

3 Replies Last Post 9 giu 2011, 18:21 GMT-4
Wes Christensen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 giu 2011, 16:42 GMT-4
Numerical artifacts from the high permeability contrasts?

Have you tried refining the mesh?
Numerical artifacts from the high permeability contrasts? Have you tried refining the mesh?
Wes Christensen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 giu 2011, 16:51 GMT-4
Numerical artifacts from the high permeability contrasts?

Have you tried refining the mesh?
Numerical artifacts from the high permeability contrasts? Have you tried refining the mesh?
Marios Karaoulis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 giu 2011, 18:21 GMT-4
I tried the finest mesh, and I still get those effects.
Can this be related to boundary conditions?
I tried the finest mesh, and I still get those effects. Can this be related to boundary conditions?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content