Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Model of planar capacitance
Posted 7 ago 2018, 01:08 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
Hi everyone, I'm new to COMSOL and I need to model this within 1 week, so please bear with me if my question sounds too stupid.
I'm designing a circuit where my parallel plate capacitance gets "opened" up into a co-planar capacitance. So to begin with, I am designing a parallel plate capacitor first. After watching a few videos, I understood that I have to first make a circuit and then model my capacitance in that circuit. To do this, I made an electric circuit with a voltage source V1, an External I vs U1, ground node 1. However, COMSOL keeps giving me an error saying "The DAE is structurally inconsistent". Is this because I have not specified a resistor? My circuit is purely capacitive, so why is it necessary to specify a resistance? And if so, what value of resistance do I have to put? My capacitor "plates" are made of copper and are squares with sides of 9cm. And the spacing between the capacitor plates is 9.5cm. Also, there is a guard ring around the receive plate of the capacitor plate, how do I add this to the model? Thanks.
Hello kullboys boys
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.