Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Deformed surface area calculation

Posted 28 ago 2018, 13:38 GMT-4 1 Reply

Udit Jain
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there is any way to calculate the surface area of build geometry after deformation (for example, the change in surface area in piezoelectric material after simulation).

1 Reply Last Post 29 ago 2018, 11:16 GMT-4
Mickaël Barsive COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 29 ago 2018, 11:16 GMT-4

Hello,

You could use the "Coupling operator">"Integration" in "Definitions" node using as frame "Spatial (x,y,z)". Then in the study node, you should select "Include geometrical non-linearities". To evaluate the area, use the "Derived values" node in "Results" then use "Global evaluation" and set in "Expression": intop1(1)

I hope this helps.

For more details, please contact COMSOL technical support.

Mickaël

Hello, You could use the "Coupling operator">"Integration" in "Definitions" node using as frame "Spatial (x,y,z)". Then in the study node, you should select "Include geometrical non-linearities". To evaluate the area, use the "Derived values" node in "Results" then use "Global evaluation" and set in "Expression": intop1(1) I hope this helps. For more details, please contact COMSOL technical support. Mickaël

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content