Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

EM harvester with moving coil.

Posted 18 ott 2018, 08:16 GMT-4 Low-Frequency Electromagnetics, Structural & Acoustics, MEMS & Piezoelectric Devices Version 5.3 0 Replies

Bilel Maamer
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'am newby to COMSOL. i'm working on an EM harvester with a printed coil on a vibratng beam and a permanent magnet. I have some technical questions for the design.

1- is it possible to design a printed coil ? i was able to draw a 3D geometry with a liitle high as if it was printed and used numeric coil but it needs too much memory.

2- to use a permanent magnet i need all the structure to be housed in an air environement for boundaries condition. when i have a vibrating beam, is it possible to use a moving mesh or do i need to use fluid-structure-interaction module ? in this case must i keep the solid mechanics module or only fsi ?

Thanks

0 Replies Last Post 18 ott 2018, 08:16 GMT-4
COMSOL Moderator

Hello Bilel Maamer

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content