Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

out of memory in stationary solver

Posted 25 lug 2011, 01:23 GMT-4 Mesh, Studies & Solvers Version 4.1 2 Replies

Prthivirajan Velraju
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi

i m designing sma actuated rf mems switch using the physics of joule heating and thermal expansion. while i am computing my design error is coming like Out of memory in stationary solver..

Please any one know to solve this error.... help me........
2 Replies Last Post 16 ago 2011, 13:42 GMT-4
Jinsong Zhao
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16 ago 2011, 11:20 GMT-4
Did you try to reconfigure your PC with a larger virtual memory space? It will be slow but the case should be kept running. One solution is to increase RAM size. The other one is to add solid-state HDD and configure it as virtual memory. It will run faster then regular HDD for sure. Or you have to reduce the number of degrees of freedom (less mesh density or smaller domain size) in your simulation case.
Did you try to reconfigure your PC with a larger virtual memory space? It will be slow but the case should be kept running. One solution is to increase RAM size. The other one is to add solid-state HDD and configure it as virtual memory. It will run faster then regular HDD for sure. Or you have to reduce the number of degrees of freedom (less mesh density or smaller domain size) in your simulation case.
Joke Lee
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16 ago 2011, 13:42 GMT-4
...........................

The third way is that you should reduce the size of mesh, if the mesh (defaul = Normal) you should reduce become Coars, or Coarser...

The fourth way (if you did choose the option Refine mesh) is that you should disable /or delete that option.

Hope it goes with your way.
........................... The third way is that you should reduce the size of mesh, if the mesh (defaul = Normal) you should reduce become Coars, or Coarser... The fourth way (if you did choose the option Refine mesh) is that you should disable /or delete that option. Hope it goes with your way.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content