Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Defining a probe location using variables

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


Has this issue been sorted? In my case too, I need to define a probe with respect to a moving mesh, and my version of COMSOL (5.2a, Build 199) cannot accept the coordinates of a point definition of a probe using variables (that vary in time).

Thank you.


1 Reply Last Post 29 gen 2019, 08:30 GMT-5

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 29 gen 2019, 08:30 GMT-5

Update: I found the following Blog article that nicely describes how to setup a 'moving' probe!

https://www.comsol.com/blogs/using-general-extrusion-coupling-operator-comsol-dynamic-probe/

This helped me solve my problem.

Update: I found the following Blog article that nicely describes how to setup a 'moving' probe! https://www.comsol.com/blogs/using-general-extrusion-coupling-operator-comsol-dynamic-probe/ This helped me solve my problem.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.