Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Defining a probe location using variables
Posted 28 gen 2019, 11:50 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
The below post is related to an archived discussion
Has this issue been sorted? In my case too, I need to define a probe with respect to a moving mesh, and my version of COMSOL (5.2a, Build 199) cannot accept the coordinates of a point definition of a probe using variables (that vary in time).
Thank you.
Please login with a confirmed email address before reporting spam
Update: I found the following Blog article that nicely describes how to setup a 'moving' probe!
https://www.comsol.com/blogs/using-general-extrusion-coupling-operator-comsol-dynamic-probe/
This helped me solve my problem.