Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
problem with time dependent phase transition model
Posted 23 ott 2011, 07:06 GMT-4 Heat Transfer & Phase Change Version 4.0a 2 Replies
Please login with a confirmed email address before reporting spam
Hi all,
I've built a model which involves a phase transition.
I want to see how long does it take for the phase transition to occur.
when I run the model with range(0,2,800) it gives logical results
with the typical graph of temperature vs. time where the temperature stays the same
as long as the phase transition occurs. But, when I run with (0,2,900), the phase
transition disappears and I get a graph with a continues temperature rise.
Is there anyone who encountered the same problem or has a solution?
thank you,
Zvika
I've built a model which involves a phase transition.
I want to see how long does it take for the phase transition to occur.
when I run the model with range(0,2,800) it gives logical results
with the typical graph of temperature vs. time where the temperature stays the same
as long as the phase transition occurs. But, when I run with (0,2,900), the phase
transition disappears and I get a graph with a continues temperature rise.
Is there anyone who encountered the same problem or has a solution?
thank you,
Zvika
2 Replies Last Post 10 set 2013, 13:19 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I can make a guess, it might be something else, but when you give a series to the solver, and leave the solver settings to default "Automatic" the solver will not solve strictly at each point you give, but might skip several, depending on the Jacobian of your system (derivative of the variables), so if you reach a regular intercase, the solver might skip over the non-linear transition. Try to use an "intermediate" or "strict" stepping method. See the solver node settings
--
Good luck
Ivar
I can make a guess, it might be something else, but when you give a series to the solver, and leave the solver settings to default "Automatic" the solver will not solve strictly at each point you give, but might skip several, depending on the Jacobian of your system (derivative of the variables), so if you reach a regular intercase, the solver might skip over the non-linear transition. Try to use an "intermediate" or "strict" stepping method. See the solver node settings
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
hi
can the phase transition be stimulated in microchannel?
which module will give the best result??
thanks
ajith
can the phase transition be stimulated in microchannel?
which module will give the best result??
thanks
ajith