Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

remeshing the geometry change at each time

Posted 10 nov 2011, 06:20 GMT-5 Heat Transfer & Phase Change, Geometry, Mesh Version 4.1 2 Replies

Pavan Kumar Penumakala
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,,,

For my problem...The geometry grows in each time step...
If i want to remesh the geometry at each time step ..how i can proceed...

i am little confused
What is Deformed geometry interface ?
What is the parametric sweep
What is the difference between the both..?

thanks in advance for teh help
2 Replies Last Post 10 nov 2011, 13:20 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 nov 2011, 07:25 GMT-5
Hi

in the time solver you have a remesh tick, it's hidden under a by default closed tab, but it's in there search the doc on "remesh"

--
Good luck
Ivar
Hi in the time solver you have a remesh tick, it's hidden under a by default closed tab, but it's in there search the doc on "remesh" -- Good luck Ivar
Ashok Kumar Nallathambi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 nov 2011, 13:20 GMT-5
hi Mr.Ivar,

i also have similar problem...

for me, i want to create a mesh in such a way that the MATERIAL node & MESH node always COINCIDE. but i want new layer of MATERIAL & MESH nodes...that means domain growth in specified direction...i have tried all possibilities upto my knowledge..i couldnt succeed in comsol...

kindly give your suggestions....
hi Mr.Ivar, i also have similar problem... for me, i want to create a mesh in such a way that the MATERIAL node & MESH node always COINCIDE. but i want new layer of MATERIAL & MESH nodes...that means domain growth in specified direction...i have tried all possibilities upto my knowledge..i couldnt succeed in comsol... kindly give your suggestions....

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content