Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

flow rule and hardening work in ottosen model

Posted 10 lug 2019, 11:46 GMT-4 Geomechanics, Structural Mechanics 4 Replies

Horacio Nestor Fideleff
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to model a piece of concrete and I need information about how the ottosen concrete model in comsol adopts yield surface, pastic flow and the work hardening; someone has information about this or where to look?

Thanks for all

4 Replies Last Post 15 lug 2019, 15:14 GMT-4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 11 lug 2019, 04:26 GMT-4
Updated: 5 years ago 11 lug 2019, 04:25 GMT-4

The Ottosen model does not include any hardening. The expression for the yield surface can be found in the theory section in the Structural Mechanics User's Guide. The flow rule is associated.

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
The Ottosen model does not include any hardening. The expression for the yield surface can be found in the theory section in the Structural Mechanics User's Guide. The flow rule is associated. Regards, Henrik
Horacio Nestor Fideleff
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 12 lug 2019, 15:07 GMT-4
Updated: 5 years ago 12 lug 2019, 14:59 GMT-4

Thanks, Henrik, just one more question, the surface of failure coincides with the yield and there can be no tension state outside of it?

Thanks, Henrik, just one more question, the surface of failure coincides with the yield and there can be no tension state outside of it?
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 15 lug 2019, 02:30 GMT-4
Updated: 5 years ago 15 lug 2019, 02:27 GMT-4

Yes, that is correct.

Henrik

-------------------
Henrik Sönnerlind
COMSOL
Yes, that is correct. Henrik
Horacio Nestor Fideleff
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 15 lug 2019, 15:14 GMT-4
Updated: 5 years ago 15 lug 2019, 15:06 GMT-4

Thanks very much

Thanks very much

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content