Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary conditions

Posted 23 nov 2011, 16:56 GMT-5 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2 0 Replies

Frederic Sarry
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am using Comsol 4.2 and try to make some simulation on Surface acoustic wave. In order to begin with Comsol, I try to verify some other works (MODELLING OF INTERMEDIATE LAYER FOR LOVE MODE SURFACE ACOUSTIC WAVE (SAW) DEVICE from UNIVERSITI TEKNOLOGI MALAYSIA). Page 37, he presents the boundary conditions and he says that some of the electrical BC are set to "CONTINUITY". I think he is using Comsol 3.5 and I don't find this Electrical BC.
Moreover he put a sinusoidal signal on the electrode and I don't know where I can find this.

Thank you for your help

Fred
0 Replies Last Post 23 nov 2011, 16:56 GMT-5
COMSOL Moderator

Hello Frederic Sarry

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content