Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Drawing a repeated diamond pattern?
Posted 23 gen 2012, 21:20 GMT-5 Geometry, Parameters, Variables, & Functions, Studies & Solvers 2 Replies
Please login with a confirmed email address before reporting spam
Hi all,
I am trying to make a model in which a repeated diamond pattern is cut out of an object. Basically a 3D rectangle with diamond shaped pores, the long axis of the diamonds being parallel to the length of the rectangle. I think this is done with an array? Does anyone know how to make this model?
Thank you for any help
TC
I am trying to make a model in which a repeated diamond pattern is cut out of an object. Basically a 3D rectangle with diamond shaped pores, the long axis of the diamonds being parallel to the length of the rectangle. I think this is done with an array? Does anyone know how to make this model?
Thank you for any help
TC
2 Replies Last Post 23 set 2016, 17:47 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
in the COMSOL geometry mode you have the "copy" command, instead of just typing in 1,1,1 for x,y,z, type in:
range(0,1,3) range(0,1,3) range(0,1,3) for x,y,z or
0 1 2 3 for each x,y,z
then you will get the original one at 0,0,0 and 3 copies at 1,1,1. 2,2,2 3,3,3
I hope I'm clear ;)
--
Good luck
Ivar
in the COMSOL geometry mode you have the "copy" command, instead of just typing in 1,1,1 for x,y,z, type in:
range(0,1,3) range(0,1,3) range(0,1,3) for x,y,z or
0 1 2 3 for each x,y,z
then you will get the original one at 0,0,0 and 3 copies at 1,1,1. 2,2,2 3,3,3
I hope I'm clear ;)
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
That makes sense. I have a similar question, but it brings up different challenges. How would you make "infinitely long" patterns? For example consider the following scenario. If I had two cylinders of different diameters (S-small and L-large) that are stacked end-to-end, how would I repeat the pattern in the z-direction? The scheme would look something like:
r-dir
^
| ... S-L-S-L-S-L-S-L-S-L-S-L ...
- - - - - - ->
z-dir
Obviously, I could create many many duplicated features to achieve a similar result, but this is very inefficient. The goal is to avoid edge effects.
Thanks!
Caleb
r-dir
^
| ... S-L-S-L-S-L-S-L-S-L-S-L ...
- - - - - - ->
z-dir
Obviously, I could create many many duplicated features to achieve a similar result, but this is very inefficient. The goal is to avoid edge effects.
Thanks!
Caleb