Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

The walls condition shows the sides to not applicable

Posted 6 mag 2020, 11:09 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.5 1 Reply

Adarsh Choudhury
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone, I tried to upload an AUTOCAD drawing into COMSOL in order to simulate the fluid flow. But I am unable to assign the wall BC on the wall inside of the drawing. I have uploaded the mph file below. The left end of the big rectangle is the inlet.

Attachments:

1 Reply Last Post 6 mag 2020, 16:34 GMT-4
Akhilesh Sasankan COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 6 mag 2020, 16:34 GMT-4

You can look into the 'Interior Wall' boundary condition. Read the help section on 'Interior Wall' for more information.

You can look into the 'Interior Wall' boundary condition. Read the help section on 'Interior Wall' for more information.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content