Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Annoying bug in Parametric Sweep
Posted 24 ago 2020, 20:10 GMT-4 Studies & Solvers Version 5.4 1 Reply
Please login with a confirmed email address before reporting spam
Hello, I'm using Parametric Sweep alot, and I've notice very annoying bug (or it is just my bad). Here is the senario of the problem: 1. I set up a Parametric Sweep for first time. It worked just fine. 2. I needed to change the value in the "Parameter Value List", and run it again. However, I found out that COMSOL used the old value not the new one. The reason I found is in (Parametric Sweep under Job Configurations node). After each run, this node swiches to "User defined" instead of staying as "Parametric Sweep".
In short, the problem is that after each run, I have to remember to go to (Parametric Sweep under Job Configurations node) to change it back to "Parametric Sweep". Why does it swich after each run to "User Defined"?
Attachments:
Please login with a confirmed email address before reporting spam
I have noticed that changes the Parametric sweep settings are not automatically updated to job configurations.