Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to give thermal Insulation boundry layer if a domain is inside to the another domain
Posted 13 mar 2012, 18:54 GMT-4 Version 3.5a 2 Replies
Please login with a confirmed email address before reporting spam
hi,
I need your help as I am using the 3.5a :( but I am having the problem with insulation boundry.Because when a boundry is inside to another boundry ,There are only three options temprature , continuity and heat flux.I wanted to put insulation boundry.So how can I do that? Please guide me.
Thank You
Tassawar
I need your help as I am using the 3.5a :( but I am having the problem with insulation boundry.Because when a boundry is inside to another boundry ,There are only three options temprature , continuity and heat flux.I wanted to put insulation boundry.So how can I do that? Please guide me.
Thank You
Tassawar
2 Replies Last Post 14 mar 2012, 16:58 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
in "union mode you have continuity and cannot easily add isolation on internal boundaries. One way is to add a domain (thick "layer") and give it a low heat conductivity. Another way is to use "assembly mode" and just not include the layer in the continuity for the heat equation, but you must add all hte continuations for the other internal boundaries.
To minimise the effort, try to group as many domains as possible and make an union before leaving the geoemtry section (in assembly mode) then COMSOL will consider continuity on all internal boundaries in the domains groupes into these specific "unions" I hope I'm clear, I do not have 3.5 so I cannot give any examples
--
Good luck
Ivar
in "union mode you have continuity and cannot easily add isolation on internal boundaries. One way is to add a domain (thick "layer") and give it a low heat conductivity. Another way is to use "assembly mode" and just not include the layer in the continuity for the heat equation, but you must add all hte continuations for the other internal boundaries.
To minimise the effort, try to group as many domains as possible and make an union before leaving the geoemtry section (in assembly mode) then COMSOL will consider continuity on all internal boundaries in the domains groupes into these specific "unions" I hope I'm clear, I do not have 3.5 so I cannot give any examples
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank You so much. Your are really very kind and hleping :).
Regards,
Tassawar
Regards,
Tassawar