Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Dielectric Model

Posted 25 set 2020, 09:53 GMT-4 Low-Frequency Electromagnetics, RF & Microwave Engineering, Materials 0 Replies

Denise Widdowson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'm trying to solve for dielectric properties of a composite using periodic boundary conditions on a representative volume element (cube). I would like to apply a background field, rather than a voltage potential on two faces, so that I can have fully periodic boundary conditions. The only way I have found to do this so far is via the RF module. Is there another way this can be done? How would I go about solving for the periodic response of the system, in particular any phase shift, if the background field is AC.

Thanks,

Denise

0 Replies Last Post 25 set 2020, 09:53 GMT-4
COMSOL Moderator

Hello Denise Widdowson

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content