Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inlet and outlet boundaries - Concentric cylinders

Please login with a confirmed email address before reporting spam

Hello all,

I have two concentri cylinder with two gases flowing in each cylinder. I was able to specify the inlet boundary conditions for both of the cylinders but I wasn't able to specify outlet conditions for the inner cylinder (says not applicable). I looked at the solution after solving and didn't see any out flow from the inner cylinder. Thanks for reading! Any suggestions are appreciated!


0 Replies Last Post 29 set 2020, 00:47 GMT-4
COMSOL Moderator

Hello VD

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.