Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error in parametric sweep simulation

Posted 4 mag 2012, 15:58 GMT-4 Heat Transfer & Phase Change, Studies & Solvers Version 4.2a 2 Replies

Emanuel Benatti
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I'm trying to run a joule heating simulation on a wire that is on a sapphire substrate. The wire has a hot spot in the middle and current is flowing threw it. My idea is to determine how long takes the system to thermally relax. I'm running a parametric sweep changing the thick of the wire, but when I compute the solution I get this error message:

Error in sweep: The following feature has encoutered a problem:

The following feature has encoutered a problem:
Extrude requires distances to be distinct.
Error in multiphysics compilation.
-Feature: Compile equations: Time dependent (sol1/st1)
-Error:Extrude requires distances to be distinct.

I've checked the busbar example in the tutorials and I can't find any differences between the example and my simulation.

I'm attaching the file I'm using

Thanks

Emanuel
2 Replies Last Post 8 mag 2012, 12:36 GMT-4
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 5 mag 2012, 23:08 GMT-4
It sounds like your parameter change must have also effected the geometry or mesh in a manner that does not allow the embedded extrude to complete. Extrude will only occur in a geometry or mesh portion of the tree. You should be able to see the error in down the model tree. Look under geometry and/or mesh to find it.

It sounds like your parameter change must have also effected the geometry or mesh in a manner that does not allow the embedded extrude to complete. Extrude will only occur in a geometry or mesh portion of the tree. You should be able to see the error in down the model tree. Look under geometry and/or mesh to find it.
Emanuel Benatti
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 8 mag 2012, 12:36 GMT-4
Hi, thanks for the aswer

you were right mi problem is that the mesh gets coarser while my parametrer was changing. I manually adjusted the element size and the problem got solved.

Regards,
Emanuel
Hi, thanks for the aswer you were right mi problem is that the mesh gets coarser while my parametrer was changing. I manually adjusted the element size and the problem got solved. Regards, Emanuel

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content