Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

numerical oscillation in modelling corona discharge with coefficient form PDEs and Electrostatic

Posted 25 mag 2012, 05:18 GMT-4 Plasma Physics, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2 3 Replies

Fucheng Deng
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,everyone
I,m working on modelling corona discharge in air with coefficient form PDEs and Electrostatics interface. I'm encountering the problem of numerical oscillation in the simulation area (unexpected negative values show up), but the solver does not give error massage about convergence. Did anybody encounter the same problem? The possible reason for it is that the mesh is not fine enough. I have tried to make the mesh finer, but the problems remain. I want to know whether there are more reasons for the problems. Any advice will be greatly appreciated.
Thanks in advance.


--
fucheng
3 Replies Last Post 18 feb 2013, 10:19 GMT-5
COMSOL Moderator

Hello Fucheng Deng

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Herek Clack
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14 dic 2012, 16:29 GMT-5
Hi Fucheng - I'm also working with ESPs. Have you gotten any help with the oscillation problem you described? Either from someone in this forum or from COMSOL directly?

HC
Hi Fucheng - I'm also working with ESPs. Have you gotten any help with the oscillation problem you described? Either from someone in this forum or from COMSOL directly? HC
Eric Favre COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 feb 2013, 10:19 GMT-5
Perhaps the last reply in www.comsol.fr/community/forums/general/thread/28886/ can be of some help.
Regards,

Eric Favre
COMSOL France
Perhaps the last reply in http://www.comsol.fr/community/forums/general/thread/28886/ can be of some help. Regards, Eric Favre COMSOL France
Eric Favre COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 feb 2013, 10:19 GMT-5
Perhaps the last reply in www.comsol.fr/community/forums/general/thread/28886/ can be of some help.
Regards,

Eric Favre
COMSOL France
Perhaps the last reply in http://www.comsol.fr/community/forums/general/thread/28886/ can be of some help. Regards, Eric Favre COMSOL France

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content