Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Capacitive coupling setup

Posted 29 nov 2021, 19:35 GMT-5 Electromagnetics, Low-Frequency Electromagnetics, Results & Visualization Version 5.6 0 Replies

Selim Sağır
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am trying to model a human arm for capacitive and galvanic coupling simulation. First I am trying to see capacitive coupling results, however, I cannot understand how to design electrodes. Now I put a two electrodes as copper to both side of arm, and, grounds are seperated from arm touching air. I am trying to give a AC signal one side and observe results from other side electode.

First thing I am struggling applying an rectangle signal to electrode. What is the best way apply signal and obtain results in the time domain.

Secondly I am not sure about ground electrodes. In real world situation receiver and transceiver grounds are floating and not attached to arm while others for applying signal and monitoring signal. I am confusing how simulate that scenario in COMSOL.

Thanks for help.

Attachments:

0 Replies Last Post 29 nov 2021, 19:35 GMT-5
COMSOL Moderator

Hello Selim Sağır

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content