Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
relative permitivitty
Posted 2 ago 2012, 12:37 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
How do I measure relative permittivity of a dielectric material dried in a waveguide for 10 minutes?
The initial value of the relative permittivity is 3.5, but how do I know the value of it after drying the material?
The initial value of the relative permittivity is 3.5, but how do I know the value of it after drying the material?
1 Reply Last Post 2 ago 2012, 15:23 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
by simulation by knowing how the e_r changes with humidity,
or you can also measure the frequency respons under the drying process, then mesure somehow the humiditiy of the material and use the simulation to fit the measured data and from there extract the e_r of your material. You might nedd to add a temperature and a time analysis, depending on how you estimate the drying process (diffusion over time) whcih can also be mkdelled with COMSOL ;)
Many ways to Rome ...
--
Good luck
Ivar
by simulation by knowing how the e_r changes with humidity,
or you can also measure the frequency respons under the drying process, then mesure somehow the humiditiy of the material and use the simulation to fit the measured data and from there extract the e_r of your material. You might nedd to add a temperature and a time analysis, depending on how you estimate the drying process (diffusion over time) whcih can also be mkdelled with COMSOL ;)
Many ways to Rome ...
--
Good luck
Ivar