Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Parametric Sweep
Posted 12 ott 2022, 02:02 GMT-4 General, Studies & Solvers, Structural Mechanics Version 6.0 2 Replies
Please login with a confirmed email address before reporting spam
Hello all,
I want to perform a parametric study.
I have four variable with 4 set of values each. In all combination setting in parametric sweep it creats 256 combination of parametric set, which has to solve by COMSOL.
Now I am facing convergence error at some of the set out of 256 combination which stop the whole simulation. ( For example that in my case after runing upto 143 parametric set the simulation stop at 144th set of parameter set (convegence error). I am sure that if somehow I skip 145th set the simulation again start from 145th smoothly.
Now my question is that is there any procedure , so that I can skip some of the combination from the parametric set. ( in parametric sweep setting all combination setting).
I am highly thankful for your valuable feedbacks. Shyam
Please login with a confirmed email address before reporting spam
You can control that behavior using the On error control in the Parametric node, see the attached screenshot.
-------------------Henrik Sönnerlind
COMSOL
Attachments:
Please login with a confirmed email address before reporting spam
Okay thank you very much Henrik.