Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reaction Module

Posted 12 set 2012, 01:33 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 3.5a, Version 4.0, Version 4.0a, Version 4.1, Version 4.2, Version 4.2a, Version 4.3 1 Reply

Lindsey Jantz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm using two phase, level set and have coupled it with reaction engineering module (synchronized with multiphysics and a second model with empty geometry was automatically created) for reaction of methane and oxygen. My model runs but there is something I have not setup properly because I am unable to plot concentrations and reaction rates. I get the error "Unable to evaluate variable" and "Unable to evaluate expression".
Any suggestions? Any input would be appreciated.

Thanks,
Lindsey
1 Reply Last Post 20 set 2012, 16:48 GMT-4
Mayur
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 set 2012, 16:48 GMT-4
if possible attach your model file..
if possible attach your model file..

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content