Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inlet BCs for Mixture Model, Laminar Flow interface

Posted 26 set 2012, 12:10 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.3 0 Replies

J
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have a question related to the inlet boundary conditions for the Mixture Model, Laminar Flow interface.
As far as I understand I can only imposed a velocity or a pressure with no viscous stress (Mixture Boundary Condition) boundary condition at the inlet. With non-Newtonian flows it is actually more convinient to use a mass flow rate boundary condition - as it is possible to do with the standard Single-Phase interface.
Do you know if it possible to do the same also for this case? Perhaps adding an ODE that solves for the velocity profile?

Any suggestion is more than welcome,

Thanks,

J
0 Replies Last Post 26 set 2012, 12:10 GMT-4
COMSOL Moderator

Hello J

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content