Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
bar simulation
Posted 9 ott 2012, 22:26 GMT-4 Version 4.3 2 Replies
Please login with a confirmed email address before reporting spam
i have a bar that is applied a force from both side. bar has a hole in the middle of of it and at a certain point bar is fillet to a smaller area. i draft the solid model with solid works and saved it as sldt file and import it to the comsol. but when i try to simulate for stress analysis for fillet and hole...
a. bar gets deformation in the direction of where there is no external forces
b. comsol simulation gives 20% error compare to hand calculation from hibbeler mechanic of materials.
any idea what i am doing wrong, or is there any similar simulation i can compare mine . thank you .
a. bar gets deformation in the direction of where there is no external forces
b. comsol simulation gives 20% error compare to hand calculation from hibbeler mechanic of materials.
any idea what i am doing wrong, or is there any similar simulation i can compare mine . thank you .
Attachments:
2 Replies Last Post 10 ott 2012, 13:10 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it could be the effect of nu the Poisson coefficient that links transverse to linear stress (it's a true phenomena, and often simplified/ignored in hand calculations).
Try setting nu = 0 and see. You ca observe it in flexure, of a regular bar, the stress changes along the top/bottom height region, as there is no more material that symmetries the transverse stress build-up
--
Good luck
Ivar
it could be the effect of nu the Poisson coefficient that links transverse to linear stress (it's a true phenomena, and often simplified/ignored in hand calculations).
Try setting nu = 0 and see. You ca observe it in flexure, of a regular bar, the stress changes along the top/bottom height region, as there is no more material that symmetries the transverse stress build-up
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
There is deformation perpendicular to the force direction is most likely due to Poisson's effect as Ivar noted. Regarding the difference between simulation and hand calculations, I suggest two things: (i) double check that you are using the appropriate formulae, and (ii) refine the COMSOL mesh to see if the results change. Also the distance between the fillets and the hole may not be big enough to totally isolate the stress concentrations resulting from these two features.
Nagi Elabbasi
Veryst Engineering
Nagi Elabbasi
Veryst Engineering