Confusion about Zref and Z0 in TEM Port

Please login with a confirmed email address before reporting spam

Hi everyone, I am new to RF modeling in COMSOL. I need to model a rectangular coax cable (an inner and outer rectangular conductor forms the ground and potential surface) which is connected to further structures in a 3D EM, frequency domain model. To acomplish this, I am using the TEM Port type BC. I am confused by the fact that this port type requires the the user to add a characteristic impedence Zref, but the output of the simulation gives the port Z0. What is the difference between Zref and the output Z0 for the TEM port type (should these be the same number?), and is this the correct port to use to model my rectangular coax?

Thanks,

Jacob


0 Replies Last Post 20 giu 2024, 14:11 GMT-4
COMSOL Moderator

Hello Jacob van de Lindt

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.