Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing in a thin fracture

Posted 4 feb 2013, 05:51 GMT-5 Fluid & Heat, Chemical Reaction Engineering, Mesh Version 4.3 0 Replies

Nawaz Ahmad
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am trying to generate mesh for 2D geometry with dimensions(fracture-matrix):

i) 0.1mm x 0.1m for fracture
ii) 0.05m x 0.1m for adjacent rock-matrix

Due to smaller fracture width there is dense mesh generated and it becomes computationally expensive especially for reactive transport simulations.

May anyone like to help about what is the best strategy to get computationally efficient mesh.

Regards,

Ahmad,
KTH

0 Replies Last Post 4 feb 2013, 05:51 GMT-5
COMSOL Moderator

Hello Nawaz Ahmad

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content