Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Failed to generate mesh
Posted 27 feb 2013, 17:57 GMT-5 Low-Frequency Electromagnetics Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hi all,
I am trying to simulate the magnetic field of a permanent magnet. Initially the simulation worked. Later I changed the length of the magnet but an error arose saying
A problem arose when building mesh feature 'Free Tetrahedral 1'.
Failed to generate mesh for domain.
- Domain: 2
Failed to insert point.
- x-coordinate: -6
- y-coordinate: 40
- z-coordinate: 24.8202
Internal error in mesh initialization.
- Detail: Failed to determine cavity.
Error in multiphysics compilation.
I cannot figure out the problem. If I change the lenght to previous value it works. But if I make the magnet longer the same error pops up. Help please
I am trying to simulate the magnetic field of a permanent magnet. Initially the simulation worked. Later I changed the length of the magnet but an error arose saying
A problem arose when building mesh feature 'Free Tetrahedral 1'.
Failed to generate mesh for domain.
- Domain: 2
Failed to insert point.
- x-coordinate: -6
- y-coordinate: 40
- z-coordinate: 24.8202
Internal error in mesh initialization.
- Detail: Failed to determine cavity.
Error in multiphysics compilation.
I cannot figure out the problem. If I change the lenght to previous value it works. But if I make the magnet longer the same error pops up. Help please
1 Reply Last Post 28 feb 2013, 01:50 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I do not believe anybody can help like that you must upload the model or a bit more, apart from some funny mesh settings, incompatible with your geoemetry I cannot tell ;)
--
Good luck
Ivar
I do not believe anybody can help like that you must upload the model or a bit more, apart from some funny mesh settings, incompatible with your geoemetry I cannot tell ;)
--
Good luck
Ivar