Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D AC Coil Setup for Magnetic Induction Tomography

Posted 27 mar 2013, 03:29 GMT-4 Low-Frequency Electromagnetics, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2, Version 4.2a 1 Reply

Firas El-Hamed
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have managed to create a simulation of a coil in 2D, using just a magnetic field source, however I would like to replace this with a frequency dependent magnetic field. How would I do this?

Best Regards,
Firas
1 Reply Last Post 27 mar 2013, 16:12 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 27 mar 2013, 16:12 GMT-4
Hi

I do it by using frequency sweep solvers, a surface current around a cylindrical air enclosure, and two end sides of the cylinder as magnetic conduction. This gives me an oscillating magnetic B field along and parallel to Bz

--
Good luck
Ivar
Hi I do it by using frequency sweep solvers, a surface current around a cylindrical air enclosure, and two end sides of the cylinder as magnetic conduction. This gives me an oscillating magnetic B field along and parallel to Bz -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content