Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
why does deformation remain same?????
Posted 14 apr 2013, 06:27 GMT-4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Results & Visualization, Structural Mechanics Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
hi,
i have designed a pressure sensor... i am getting different displacement values as output but deformation for all applied pressure is same....why is it so??? wat should i do to get the deformation corresponding to applied pressure
i have designed a pressure sensor... i am getting different displacement values as output but deformation for all applied pressure is same....why is it so??? wat should i do to get the deformation corresponding to applied pressure
1 Reply Last Post 14 apr 2013, 08:47 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
what do you mean by deformations are the same ? is it on the 2D or 3D graphics with deformation sub node ?
If so it's probably the automatic scaling between the different pressure values, the displacement appears the same, but the units of the scale changes each time => set the rescaling factor to a constant value
Another way to check is to cut your membrane by a Data Set cut line (or by having the geometry split in the middle of the membrane), and you do a 1D displacement ) or better (u,v,w) line plot across your membrane, for all parametric pressure values, then you have everything on the same scale
--
Good luck
Ivar
what do you mean by deformations are the same ? is it on the 2D or 3D graphics with deformation sub node ?
If so it's probably the automatic scaling between the different pressure values, the displacement appears the same, but the units of the scale changes each time => set the rescaling factor to a constant value
Another way to check is to cut your membrane by a Data Set cut line (or by having the geometry split in the middle of the membrane), and you do a 1D displacement ) or better (u,v,w) line plot across your membrane, for all parametric pressure values, then you have everything on the same scale
--
Good luck
Ivar