Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Heat Transfer in square Channel
Posted 30 apr 2013, 08:03 GMT-4 Heat Transfer & Phase Change Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Dear All,
I want to simulate the heat transfer between a fluid and a square channel.
My boundary conditions are:
- Initial temperature of the fluid 293K
- Inlet velocity 0.2 m/s
- Inlet T of the fluid 293K
- Outlet P of the fluid = 0
- Wall T of the channel 473K
- Outflow (9 fluid exit)
The velocity Plot is ok, but I don't know if the temperature profile is reasonable.
Is it possible that the temperature is the same in all the channel with exception for the entrance?
Thank you in advance for your reply.
I want to simulate the heat transfer between a fluid and a square channel.
My boundary conditions are:
- Initial temperature of the fluid 293K
- Inlet velocity 0.2 m/s
- Inlet T of the fluid 293K
- Outlet P of the fluid = 0
- Wall T of the channel 473K
- Outflow (9 fluid exit)
The velocity Plot is ok, but I don't know if the temperature profile is reasonable.
Is it possible that the temperature is the same in all the channel with exception for the entrance?
Thank you in advance for your reply.
1 Reply Last Post 30 apr 2013, 09:35 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
No, temperature plot does not look physical.