Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Encountering error during meshing

Posted 13 giu 2013, 00:36 GMT-4 Mesh Version 4.3b 2 Replies

Doyle Baker
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

when I try to run a mesh i encounter the following error message: "Edge is much shorter than the specified minimum element size." I do not know what this means and any advice on how to get rid of this error would be very helpful
2 Replies Last Post 28 giu 2013, 08:42 GMT-4
Doyle Baker
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24 giu 2013, 13:51 GMT-4
If necessary I can upload the file in question if that will help any
If necessary I can upload the file in question if that will help any
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 giu 2013, 08:42 GMT-4
Doyle-

I believe what you are describing is simply a warning not an error.

You can get rid of the warning by decreasing the minimum element size in the Size settings of your mesh operation. This minimum element size is ignored if you have any small geometric entities that need to be resolved by the mesher. Hence, the warning.

Best regards,
Josh Thomas
AltaSim Technologies
Doyle- I believe what you are describing is simply a warning not an error. You can get rid of the warning by decreasing the minimum element size in the Size settings of your mesh operation. This minimum element size is ignored if you have any small geometric entities that need to be resolved by the mesher. Hence, the warning. Best regards, Josh Thomas AltaSim Technologies

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content