Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

CFD Immiscible Multiphase - Mixture Model vs. Level Set

Posted 24 set 2013, 09:36 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD) 0 Replies

David Perez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am looking to model water droplets flowing in an oil pipeline, where the water concentration is roughly 5% by volume. The flow will be turbulent. The objective of the model will be to measure concentration of water as a ratio of concentration in the top and bottom halves of the pipe after passing through a static mixing device.

The level set method seems to be the better model for this situation, with it's explicit inclusion of surface tension, but will be computationally demanding relative to the mixture model. Will the mixture model be able to account for surface tension rather than just drag forces, or is there any way to implement surface tension into the model? Or would I be better off just letting the level set solutions run their course?

0 Replies Last Post 24 set 2013, 09:36 GMT-4
COMSOL Moderator

Hello David Perez

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content