Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Elliptical cylinder

Posted 18 nov 2013, 08:28 GMT-5 Fluid & Heat, Geometry Version 4.3 3 Replies

André Ødegårdstuen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am completely new to comsol, so please forgive me for posting a problem I suspect have a simple solution. I have tried to search for a solution myself, unsuccessfully.

In a microfluidic problem I need to use a pipe with an elliptical cross section. I have attempted to use a parametric surface and then convert it to a solid, but I get a warning that the output is empty.

Any help or tips would be much appreciated.

3 Replies Last Post 8 giu 2016, 21:15 GMT-4
COMSOL Moderator

Hello André Ødegårdstuen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Ningyu Wang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 8 giu 2016, 10:34 GMT-4
Hi André,

I'm facing the same problem. Have you found the solution? Thanks!

Best,
Ningyu
Hi André, I'm facing the same problem. Have you found the solution? Thanks! Best, Ningyu
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 8 giu 2016, 10:48 GMT-4
You can draw an ellipse in a workplane and extrude it.
Best regards,
Jeff
You can draw an ellipse in a workplane and extrude it. Best regards, Jeff

Attachments:

Ningyu Wang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 8 giu 2016, 21:15 GMT-4
It works. Thanks a lot!
It works. Thanks a lot!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content